If the temperature of the water in the water tank of the bulk feed carrier is always at a high temperature, then such a situation will cause the combination of calcium, magnesium, and hydrocarbon ions in the water to form an inability to Water-soluble magnesium carbonate and calcium carbonate, this is what everyone said in the daily water base. Then, with the constant concentration of water and the law, the content of water alkali becomes scale after a constant addition until a saturated level. After the tank of the bulk feed carrier is used for a long time, the removal of scale will become difficult. However, if the cleaning is not done in time, the components inside the engine will be damaged. This will cause the fuel consumption of the bulk feed carrier to gradually increase. Therefore, cleaning the scale of the tank is also an extremely important issue. The common cleaning methods for water tanks can be divided into the following three types: 1. Manual cleaning: Disassemble the tank of the transporter and use a shovel, a scraper or an artificial hammer to clean the scale. However, such a cleaning effect is not very good, the efficiency of descaling is also relatively low, and its artificial labor intensity also consumes very well. If the scale is not clean, it will cause secondary damage to the vehicle's water tank. 2. The use of scale cleaning agent: the use of scale cleaning agent or the need to remove the tank of the bulk feed truck, but the effect of removal is not very thorough, the odor left by the cleaning agent will be relatively large, and its corrosiveness is also relatively strong , It will be easy for the tank to become old and shorten the service life. 3. Use professional vehicle water tank cleaners: The use of professional tank cleaners does not require the tank to be removed, and it can also be cleaned without stopping. Special detergents can be added to the water circulation system of the bulk feed carrier , allowing it to circulate slowly or after 20 to 30 minutes after the vehicle is normally running, and then discharge the vehicle tank and the descaling agent inside the system. If you drop it, you can rinse it with water repeatedly and repeatedly, so that you can effectively remove all kinds of harmful substances such as scale and water scale in the engine water circulation. (Text / Sun Ni)
Air Compressor is a general industrial equipment, it is very important for industries. With the help of air compressor, air is compressed and treated by various methods. For Nitrogen Generator and Oxygen Generator, air compressor is used to provide the raw material, the compressed air. There are several kinds of air compressor, piston type, screw type and centrifugal type.
Because nitrogen/Oxygen Generators are designed for non stop operation, Screw Air Compressor is widely used. This screw air compressor provide compressed air with pressure up to 13 bars, good for the operation of nitrogen/oxygen generators.
Gas Compressor specification:
Capacity:1-200 m3/min
Max pressure: 13 bar
Air Compressor Air Compressor,Screw Air Compressor,Mobile Air Compressor,Durable Air Compressor Shandong Gamma Gas Engineering Co. Ltd. , https://www.gammagas.com
September 14, 2019